No hot water at all
A burnt-out heating element or a failed thermostat. On a scaled element this is the usual end point, and both parts are inexpensive.
Electric water heaters in Dubai fail for one reason more than any other: scale. Hard water coats the element and the tank, the heater works harder, and eventually the element burns out or the thermostat fails. Naveed Electronics repairs, descales, replaces and installs water heaters across Dubai — ceiling-mounted, wall-mounted and instant units.
Find your symptom below. Each one tells you the usual cause, so you know roughly what you are dealing with before you call.
A burnt-out heating element or a failed thermostat. On a scaled element this is the usual end point, and both parts are inexpensive.
Heavy scale insulating the element, or a thermostat that has drifted low. Descaling often restores full performance.
The element has failed to earth, or moisture has reached the terminal cover. This is a genuine electrical fault, not a nuisance trip.
A corroded tank, a failed pressure-relief valve, or perished connections. Isolate the supply and call — ceiling units can damage a lot before anyone notices.
Scale on the tank base trapping water underneath, which boils and pops. A sign the unit badly needs descaling.
Scale has reduced the usable tank volume, or the lower element on a twin-element unit has failed.
Everything below is handled in-house by our own technicians, never subcontracted out.
Dubai's water leaves mineral deposits that build on the heating element and the base of the tank. A scaled element has to run hotter to transfer the same heat, which shortens its life, raises your electricity use, and eventually causes failure. Descaling and flushing a heater every couple of years is a small job that meaningfully extends its life. When we replace an element we always flush the tank at the same time, otherwise the new element scales up just as fast.
Many Dubai apartments have the water heater concealed above the bathroom ceiling. It is out of sight, so a slow leak from a corroding tank or a weeping pressure-relief valve can soak the ceiling and cabinetry for weeks before anyone notices. If you see staining on a bathroom ceiling, have it checked rather than waiting. Access panels make servicing far easier, and we can advise on fitting one if yours has none.
Every storage heater has a pressure-relief valve, and it is a safety device. People sometimes cap a dripping valve to stop the noise, which is dangerous — the valve is dripping because it is doing its job, and blocking it removes the tank's protection against overpressure. A dripping valve needs replacing, not plugging.
Elements, thermostats and valves are all worth repairing. A tank that has corroded through is not — the tank is the appliance. If we find the leak is coming from the tank body rather than a fitting, we will tell you plainly that replacement is the only sensible option, and we can supply and install the new unit.
We do not publish a fixed price list, because quoting a number before seeing the fault would be guesswork. Here is what actually moves the price, so you can judge whether a quote you are given is fair.
For water heaters, an element, thermostat or pressure-relief valve is inexpensive, with a descale and flush done at the same time. Pipework repairs are mid-range. A corroded tank cannot be repaired and the unit has to be replaced.
How it works: you get a realistic range on the phone, then a fixed quote after diagnosis. Nothing is opened, ordered or charged until you approve that figure.
Usually a burnt-out heating element or a failed thermostat, and in Dubai the underlying cause is nearly always scale build-up. Both parts are inexpensive, and we flush the tank at the same time so the new element does not scale up immediately.
That means the element has failed to earth, or moisture has reached the terminal cover. It is a real electrical fault. Leave the heater isolated and call us to test and replace the faulty element.
Have it checked promptly. Concealed ceiling-mounted heaters can leak from a corroded tank or a failing pressure-relief valve, and because the unit is out of sight the damage often spreads before anyone notices.
Roughly every two years for a household unit, and more often if you have noticed longer heat-up times or rumbling noises. Descaling extends element life and reduces running cost.
It depends where the leak is. Fittings, connections and pressure-relief valves are all repairable. If the tank body itself has corroded through, the unit needs replacing — we will tell you which you have.
Yes. We supply, install and commission ceiling-mounted, wall-mounted and instant units, including the pipework and electrical connection.
They do amazing job with my Miele washing machine repair in Downtown. Best service, quick response. Ahmed came, diagnosed the problem in a minute and fixed my washing machine. Highly recommended.
It is amazing service. Just in 30 minutes all issues were repaired at a good price. I recommend this for cooking gas service.
Ahmed did my Miele washing machine repair in Jumeirah Park. Excellent and very professional service. I'm very happy. Highly recommend.
Call the workshop directly and speak to a technician, not an operator. Most repairs are booked in under two minutes.
Serving Dubai Marina, JBR, Palm Jumeirah, Jumeirah, JVC, Emirates Hills, The Springs, Arabian Ranches, Motor City, Al Furjan, Al Barsha, Business Bay, Downtown Dubai, Deira, Mirdif and all other areas of Dubai — plus Sharjah, Ajman and Abu Dhabi by appointment.